Cooler Master 120v/Elite 130 Push/Pull Question

[3derpderpderp]

I am getting a Cooler Master Elite 130 and a Seidon 120v and I'm not sure if I will have to buy special screws and a y-connector in order to set up a push/pull setup with the included 120mm case fan. Will I need to buy those things in order to set up a push/pull with the stock fan or are the materials all included. My assumption is that one fan and the radiator can be mounted to the case screws and that I can use the included screws with the 120v to add the second fan onto the radiator and that I will have to buy the y-connector seperately. Thanks for any help in advance

Does anyone else here think that Tom's should have a cooling section in the forum?

 

[commycharb]

if you want 2 fans on the radiator you will need 8 long black bolts. 4 per fan the 120 v comes with 4 but my came with 8. lucky me. However I suppose if you hollowed out 4 screw holes on one side of one fan you could pass the small case screws through the hole and screw them into the holes on the opposite side of the fan and then into the rad. just be careful not to puncture the rad.