Cpu tempritures all over the place

[cr4ig]

I have just fitted the corsair h60 to my computer and been getting very wierd temps. Using the corsair link I get anywhere from 50 to 70 decrees c with speed fan I get 0 now but I was getting 20 to 37 decrees and with another program it was measuring just one of my cores and it got 17 decrees which I think is impossible when it is near the room temperature.
I have the pump connected to the 3 spin cpu fan header 2 which I set to full rpm in the bios. I then connected the fan that is on the other side of the radiator to to just a normal chassis fan header. I cannot work out how I'm getting such wierd tempritures especially with the air coming out the radiator is cold. I don't know what to do. I have an asrock fm2 a85x e4 motherboard and a amd a10 6800k apu thanks

 

[scout_03]

the pump goes to cpu fan 1 and the fan goes to cpu fan 2 that the way they should work .

 

[cr4ig]

i know. but i already tried that and it registered the pump as a fan and kept decreasing the voltage going to it depending on the temperature of the cpu. so i had to change it so it gets a constant 12v otherwise it can damage it.

 

[scout_03]

what the cooler booklet tell you about pluging the pump in the motherboard . this means pump run low on low temp and speed up on load .

 

[cr4ig]

i will try it again and tell you how it gets on. in the mean time can you give me an accurate way to measure cpu temps because im getting very different results from what programs im using

 

[scout_03]

i use this on the sensor page it give temp ,fan speed and voltages http://www.hwinfo.com/download.php

 

[cr4ig]

also is there anyway to have the pump going on full as it is quite quite and just the fans that slow down?

 

[scout_03]

give the name and model of that water cooler i will check .

 

[cr4ig]

its the corsair h60 CWCH60/RF

 

[scout_03]

the pump should be directly to the cpu fan header read this http://www.corsair.com/en-us/blog/2011/march/mounting-the-hydro-series-h60-cpu-cooler-to-your-intel-motherboard

 

[cr4ig]

i have read through it and it is what i have done with the pump connector, i have connected it to the cpu fan header port and the fan to the chassis fan and its is on full power and is still saying i am at 53 degrees on the coursair fan controller and -60 on the speedfan and 13 on some other one i just dont get it at all.

 

[cr4ig]

Sorry for asking so many questions but this is really annoying how its not working the way i thought it would.

 

[scout_03]

if you still have some cooling paste i would reinstall the pump on cpu and check if you peel of the plastic film from under before the first install ,for the weird temp i dont know what to tell but check in bios there should be more accurate .

 

[cr4ig]

i will have to and get some cooling paste i used the stock one from the cooler.and im sure i removed the plastic cover haha thanks.

 

[scout_03]

get some mx2 or mx 4 they do not need cure time the other thing do you feel if the any liquid running in the tubing whne sytem is on and pump work .

 

[cr4ig]

thanks think i will get some of that then and the tubes are vibrating so im guessing that the pump is working but i cant really hear any sounds over the fans.

 

[scout_03]

could it be that there is some air in the system check for leak and if you prss one of the tube does the vibration stop .