I got 4x16 5200mhz (I could not get 2x32 anywhere) but I had problems since the first day a few days ago.
I set the xmp to 5200 as the default was set to 4800 but had issues.
I ran memtest a couple days later and in 5200 it threw a lot of errors.
Disabled xmp and the memory was set to 4533 and no errors
Set it to 4800mhz manually (just the speed, did not change any timings) and again, lots of errors.
Set it back to auto which sets it to 4533mhz and no errors so far.
I researched and apparently plenty of motherboards have issues with ddr5 and 4 slots but I wanted to know if I should RMA them (it is not as easy to do here but it is doable) or it is just a limitation on the compability and not actually a faulty hardware.
I will test 2 sticks at 5200mhz once this current memtest finishes on that system but I wanted some input in case someone already had this issues.
I don't have a problem to run the 4 sticks at lower speed at the moment or to stick with them, just want to know if they are working fine and it is a compatibility issue or I need to send them back.
The 4 modules are 8 numbers apart on the serials so the are even from the same run.
Thank you very much.
I set the xmp to 5200 as the default was set to 4800 but had issues.
I ran memtest a couple days later and in 5200 it threw a lot of errors.
Disabled xmp and the memory was set to 4533 and no errors
Set it to 4800mhz manually (just the speed, did not change any timings) and again, lots of errors.
Set it back to auto which sets it to 4533mhz and no errors so far.
I researched and apparently plenty of motherboards have issues with ddr5 and 4 slots but I wanted to know if I should RMA them (it is not as easy to do here but it is doable) or it is just a limitation on the compability and not actually a faulty hardware.
I will test 2 sticks at 5200mhz once this current memtest finishes on that system but I wanted some input in case someone already had this issues.
I don't have a problem to run the 4 sticks at lower speed at the moment or to stick with them, just want to know if they are working fine and it is a compatibility issue or I need to send them back.
The 4 modules are 8 numbers apart on the serials so the are even from the same run.
Thank you very much.