Yesterday my Dell R710 server froze, causing me to have to manually shut it down. When i tried to boot it back up it was no longer detecting my HDD. It was running a 1TB Seagate Barracuda, i was just getting it setup so it only had OS on it.
It has a PERC 6/i raid controller, when i go into the raid controller boot it says no configuration. I get CMD open and run diskpart and the only drive its showing is the USB i used to to instal my OS and get me the CMD screen.
What i have tried:
I have tried to swap it out with 2 other HDDS i have sitting around (1TB WD Black, 1.5 TB Seagate)
All these HDDs are showing up and working just fine when i put them into a different system.
Edit:
HDD shows up as Virtual drive when i click New Configuration in the raid controller screen. I click initilize and after a long wait it showed as 40% and then it disappeared and showed NO Configuration.
It has a PERC 6/i raid controller, when i go into the raid controller boot it says no configuration. I get CMD open and run diskpart and the only drive its showing is the USB i used to to instal my OS and get me the CMD screen.
What i have tried:
I have tried to swap it out with 2 other HDDS i have sitting around (1TB WD Black, 1.5 TB Seagate)
All these HDDs are showing up and working just fine when i put them into a different system.
Edit:
HDD shows up as Virtual drive when i click New Configuration in the raid controller screen. I click initilize and after a long wait it showed as 40% and then it disappeared and showed NO Configuration.