Hello,
I just started building computers a month ago, so I'm a novice when it comes to this. Anyway, I think I might have killed my motherboard. I just finished building a new PC and was able to boot it up fine with the exception of the power LED not turning on. So like the genius I am, I adjusted the front panel connectors with the power cable still plugged in. And now nothing. Not even a slight movement of the fan.
Is it possible to fry the board while just adjusting the front pannel connection?
FX-6100
ASRock 880GM-lE FX
On board graphics
Corsair TX750 psu
WD 500GB
Corsair Vengeance 2x4 8GB
Thermaltake V3 Black Edition Case
I just started building computers a month ago, so I'm a novice when it comes to this. Anyway, I think I might have killed my motherboard. I just finished building a new PC and was able to boot it up fine with the exception of the power LED not turning on. So like the genius I am, I adjusted the front panel connectors with the power cable still plugged in. And now nothing. Not even a slight movement of the fan.
Is it possible to fry the board while just adjusting the front pannel connection?
FX-6100
ASRock 880GM-lE FX
On board graphics
Corsair TX750 psu
WD 500GB
Corsair Vengeance 2x4 8GB
Thermaltake V3 Black Edition Case