having problem with amd fx8350

[Jose Santiago]

hi everyone i am having this problem with my pc i overclock the pc and start shutting down or give me some kind of error using win 10 or pc freeze hwmonitor say that my cpu is running at idle at 37c to 40c even if i overclock to 4.3 system crash
my pc spec are
asus 970 pro gaming/aura new
fx 8350
pny ddr3 16gb 1600mhz
corsair h80i in push and pull
case is a phantek eclipse 400 new
fan setup are 3 120mm in front 2 on top new
power supply corsair cx750m bronze new
gtx 760 2gb

 

[QARTS]

Hi,try to switch the RAMs in other slots.

 

[maxwellmelon]

how much did you raise the cpu voltage when your setting it at 4.3ghz?

 

[bicycle_repair_man]

Sounds like you haven't given the CPU enough voltage, but regardless, don't overclock on a CX750M. It uses cheap capacitors and thin-gauge wiring and isn't suitable for overclocking at all. Get yourself a better PSU before you consider overclocking.

 

[Jose Santiago]

for the cpu volt i was overclocking at 4.5 with 1.43volts i test all 4 ram slot and it keep doing the same only stock setup the pc runs and dont shutdown

 

[Jose Santiago]

how much did you raise the cpu voltage when your setting it at 4.3ghz?

at 4.3 is at 1.35 volt

 

[sizzling]

Overclocking on such a poor quality PSU is asking for trouble. Not only can a low quality PSU limit any overclocking potential but it actually puts your whole system at risk.

 

[Jose Santiago]

Overclocking on such a poor quality PSU is asking for trouble. Not only can a low quality PSU limit any overclocking potential but it actually puts your whole system at risk.

any recommendation for a good psu

 

[maxwellmelon]

I would raise your cpu voltage up some. prob need to be closer to 1.45-1.46 volts at 4.5ghz. if its fine at stock chance are your not raising your voltage enough for the higher overclock. also consider bumping your northbridge up .05 volts if you haven't adjusted it all yet.

try running prime95 test and watch your temps.

i don't see it as a power supply issue when hes trying to overclock and doesn't sound like hes dialed in the settings yet.

i know each cpu is different and but running only .07 volt increase over default fx 8350 voltage is not much for 500 MHz increase. (assuming hes disabled turbo boost) if he left turbo boost on he will have to boost the voltage even more

 

[Jose Santiago]

I would raise your cpu voltage up some. prob need to be closer to 1.45-1.46 volts at 4.5ghz. if its fine at stock chance are your not raising your voltage enough for the higher overclock. also consider bumping your northbridge up .05 volts if you haven't adjusted it all yet.

still doing the same right now is stable at 4.3