[SOLVED] Help with a new 3060 TI showing showing no output across any ports

[BladesOfTheDeep]

CPU: 5600x Ryzen 5
PSU: Corsair 850 (80+ Gold)
MOBO: ROG Strix b450

I am switching from a Radeon RX 590 (Fatboy if it matter) and ran DDU with the shutdown after, the seating went seamlessly and the card fans run when the PC is turned on. I tried initially with HDMI and since my monitor can't support display port I got an adapter to try and make it work but no progress there. I highly doubt CMOS will do anything and have no integrated graphics to take over. I would guess the card is the issue but it's the second time (I've returned and re-ordered the same card (Venus 3x 3060TI))

Just don't know how to progress from here as I assume the issue lies within drivers or hardware.

 

[zinkles]

do you have the previous card with you? if so, does it work when you plug in?

 

[boju]

Do you still have 590? If you do, try set pcie link speed to gen 3 then swap cards.

From manual.

PCIEX16_1 Mode
This item allows you to set the link speed for first VGA slot.
Configuration options: [Auto] [GEN 1] [GEN 2] [GEN 3]

Drivers aren't loaded during post/bios, not until Windows, so can rule out software. Sorta helps narrow down to being a hardware/psu/display cable/compatibility (ie link speed) issue.

 

[BladesOfTheDeep]

do you have the previous card with you? if so, does it work when you plug in?

The 590 rx still works and I can use it to change stuff around as needed in BIOS using that.

 

[BladesOfTheDeep]

Do you still have 590? If you do, try set pcie link speed to gen 3 then swap cards.

From manual.

PCIEX16_1 Mode
This item allows you to set the link speed for first VGA slot.
Configuration options: [Auto] [GEN 1] [GEN 2] [GEN 3]

Drivers aren't loaded during post/bios, not until Windows, so can rule out software. Sorta helps narrow down to being a hardware/psu/display cable/compatibility (ie link speed) issue.

That would be in BIOS or just in cmd for Windows

 

[boju]

Sorry should have said motherboard manual. In bios.

 

[BladesOfTheDeep]

Sorry should have said motherboard manual. In bios.

I just tried this and still no connection to HDMI or DP but the computer still boots (GPU fans spin, white motherboard light) until I pressed the power after 10 minutes or so.

 

[BladesOfTheDeep]

I also made an error in the initial post this is a 4060ti vents 3x I apologize

 

[boju]

I can't think of any other reasons why. It should work. What's the chance you got the same card back. You plugging entire pcie 8 pin connector?

 

[BladesOfTheDeep]

I can't think of any other reasons why. It should work. What's the chance you got the same card back. You plugging entire pcie 8 pin connector?

I ended up fixing the issue by flashing my BIOS with the old card in and then switching to the new card, I still appreciate the help though.