help with testing

[srbraith]

I just have a few questions..

Im building my first WC rig and dont know how and if I should test the loop...

If i do, do I simply connect my power supply only to my pump and let it run for a couple hours?

Can i test it with my motherboard mouted in my case?

Im hoping I can get everything wired nice and clean and then just disconnect the plugs that go into my power supply and just give power to my pump.

Suggestions?

 

[Lupiron]

You didn't specify what all is in the loop, but since you mentioned placing the Mobo in first, I assume The cpu and or NB is in the loop.

It is prolly recommended that you test your loop outside the case, where you can set it in a safe position where one leak wont ruin it all!

Just let it run for a small amount of time after making sure all tubing and fittings are on nice and tightly.

(Not to mention it's easier to get air bubbles out of things when you can maneuver the components around.)

But... if you un plug everything else, I dont see a problem, if it explodes with liquid all over, just make sure the junk is dry before you give it any power. And that liquid can be hard to clean, because it lubes as it goes!

I mean, you do know that you did a good job, right?

--Lupi