I installed and tuned my Hauppauge 2250. Under the channel list, it shows more than 70 channels. When I go past channel 20, all I have is a blue screen and static. The coax cable I am using is the same I used for the set top box. With the set top box connected to the TV I receive 200 channels. When I had the set top box connected to the 2250, I had a low bit rate notice. I figured if i directly connected the coax cable that runs from the cable box outside, the channels would display fine. Did I install something incorrectly? I have the most recent drivers installed from the Hauppauge website.
Sys Specs:
Win 7 64bit
8GB ram
gtx 280
I am watching TV on the computer just fine, but only up to channel 20. What can I do! I have an amplifier for my room with the cable modem and TV split. Should I try that out on the HTPC? Should I even go through the hassle?
thanks in advance,
-Bro
Sys Specs:
Win 7 64bit
8GB ram
gtx 280
I am watching TV on the computer just fine, but only up to channel 20. What can I do! I have an amplifier for my room with the cable modem and TV split. Should I try that out on the HTPC? Should I even go through the hassle?
thanks in advance,
-Bro