[SOLVED] I need a case

Oct 21, 2019
17
0
10
I need a cheap mid tower case that can fit a micro atx board, and a gtx 1060. anything you guys can recommend? Preferably from amazon but it needs to be mid tower with good airflow and easy component installation.
 
Solution
https://pcpartpicker.com/product/3MPfrH/deepcool-case-tesseractsw
this is my go to suggestion for a basic case. it has lights but do not hold that against it.
ed69a83e8983e99b2f875c037f49a3b9.1600.jpg


a bit pricey at the Amazon
https://www.amazon.com/dp/B00NGCS7YA?tag=pcpapi-20&linkCode=ogi&th=1&psc=1

R_1

Expert
Ambassador
SSD's weigh nothing. I use a single strip of 3m double sided tape when I run out of mounting space and stick it anywhere I can.
even cheap foam tape with a 1LB rating are more than strong enough for 5 SSD's together. stuck to the bottom of the case they are not going anywhere.
 

R_1

Expert
Ambassador
mesh front, side, bottom and top vents, PSU compartment. ports. There is nothing wrong with it if that helps.
its light in weight, which means the metal may a bit on the thin and bendy side, eyes open, handle with care.
the case I suggested weighs in around the same. not a negative just a heads up.
 
Oct 21, 2019
17
0
10
mesh front, side, bottom and top vents, PSU compartment. ports. There is nothing wrong with it if that helps.
its light in weight, which means the metal may a bit on the thin and bendy side, eyes open, handle with care.
the case I suggested weighs in around the same. not a negative just a heads up.
so is it good? should i purchase it?