I have a problem:
I am building a new system. I am using the Corsair H100i PRO RGB AIO as the cooling solution to the 9600K.
My motherboard is Asus ROG Strix Z390-F. It has a total of 7 fan headers, CPU_FAN, CPU_CPU_OPT, AIO_PUMP, CHA_FAN1, CHA_FAN2, W_PUMP+ and M.2_FAN.
I have no problems getting the fans and radiator hooked up and fitted to the roof of the case. That part is done admirably easy.
Now I am in the middle of installing the pump to the CPU and before I fit it into the socket, I get stuck here. There I notice 3 cables from the pump unit:
I am building a new system. I am using the Corsair H100i PRO RGB AIO as the cooling solution to the 9600K.
My motherboard is Asus ROG Strix Z390-F. It has a total of 7 fan headers, CPU_FAN, CPU_CPU_OPT, AIO_PUMP, CHA_FAN1, CHA_FAN2, W_PUMP+ and M.2_FAN.
I have no problems getting the fans and radiator hooked up and fitted to the roof of the case. That part is done admirably easy.
Now I am in the middle of installing the pump to the CPU and before I fit it into the socket, I get stuck here. There I notice 3 cables from the pump unit:
- SATA ---- This one I know it is required to connect to the PSU SATA cable, I have no problem with it. It supplies power to the unit.
- The 3-pin female connector (according to manual, it is required to connect to the CPU_FAN header0
- A Y-split cable with two male 4 pin connectors (according to the manual, the two connectors are meant to hook up with the two fans' connectors.
Last edited: