- Feb 14, 2011
- 99
- 0
- 18,640
I have just done a SSD upgrade on my other half's laptop, rebuilding with Win 10 home 64 bit, and using a Crucial M550 128gb. The build went fine,Win 10 install, updates, software etc. The next morning went to use the laptop, it powers up but no display.
I swapped back to the old hard drive and it started fine.
So, I then reinstalled the SSD and it again powers up and no display. I do notice that the hdd light flashes once and then nothing.
Again I changed drives and now I get exactly the same as the SSD, blank screen, one flash on the HDD light.
I have tried to start with/without the battery (on mains), discharging using the power button - nothing.
Now and again when I plug the power cable in there is a short squeak through the speaker.
Hoping someone can give me some ideas.
Spec. Lenovo G550, 4gb ram, 128gb Crucial M550.
I swapped back to the old hard drive and it started fine.
So, I then reinstalled the SSD and it again powers up and no display. I do notice that the hdd light flashes once and then nothing.
Again I changed drives and now I get exactly the same as the SSD, blank screen, one flash on the HDD light.
I have tried to start with/without the battery (on mains), discharging using the power button - nothing.
Now and again when I plug the power cable in there is a short squeak through the speaker.
Hoping someone can give me some ideas.
Spec. Lenovo G550, 4gb ram, 128gb Crucial M550.
Facebook
Twitter
Instagram