Question My monitor only shows image using my old GPU, no image with new GPU or with integrated graphics ?

[Swoopi26]

Late thought: will the system boot via Safe Mode?

= = = =

I would not move the GPU to another PC - more needs to be known if at all possible.

= = = =

The glare makes it difficult to see the full ribbon cables and PCIe ports being used.

Hopefully someone will recognize and understand what those LEDs are indicating.

Do they just blink once (and you were able to capture that) or do the LED continue to blink?

Is that a cable that came with the GPU?

Solved, i edited the post

 

[beyondlogic]

Solved, i edited the post

GPU light coming on briefly is most likely it just running threw steps on start up should be fine. If you believe it's solved mark which answer solved it . If a issue should arise in future open up a new post or pm if you need a bit of further help.

 

[Swoopi26]

run 2 seperate gpu cables.

each cable provides 150w of power. no more no less.

( yes 75w is provided by the board but the card doesnt use this at all.)

the card needs 225w.

the connectors provide all of the power.

that extra connector on 1 cable is worthless does nothing.

you need 2 seperate gpu cables to the psu to the card.

GPU light coming on briefly is most likely it just running threw steps on start up should be fine. If you believe it's solved mark which answer solved it . If a issue should arise in future open up a new post or pm if you need a bit of further help.

Since you are amazing maybe you can help again here

Question - Red led permanently on in my EVGA RTX 30606ti FTW3

So a few days ago i had made another post about this same gpu, one where the gpu would turn on but i wasn’t getting any video signal, it turned out to be a power issue, more specifically it had to do with not using a daisy chain power cable, long story short i managed to fix the problem by...

forums.tomshardware.com

Also i dont know how to mark your coment as the solution