Here is my set up...
Ryzen 7 2700x
MSI x470 gaming plus
G.Skill RipJaw V 3200MHz
I bought my system about 4-5 months ago and my MSI x470 gaming plus has two X-AMP profiles for ram speed(profile 1 is 2933, profile 2 is 3200). When I first initially run my system for the first time(4-5 months ago) I was able to to set my X-AMP to profile 2 and run my ram speed at 3200 without a problem.
Until today when the problem just happened. I get into bios today just to check around and seen my ram speed only ran at 2133 even though my X-AMP profile 2 is still activated. So i tried to switch to profile 1 and save the setting and reboot the system and get into the bios again, it shown to run at 2933 without a problem. Then I tried to switch to profile 2 again to make them come back to the speed of 3200, after I save the setting and reboot the system just enter boot-loop states(it tried to boot but then shut off, repeat for about 5 times) and then it finally be able to boot up. Then I get into the bios to see if my ram will be running properly at the speed of 3200 or no, nope ! It shown that it's running at 2133 while my X-AMP profile 2 is still activate. I tried this multiple times and the result was always the same, I can't get it to run at 3200. I even tried to deactivate the X-AMP and do my own custom ram speed and voltage, still can't get it to run at 3200.
Right now I got no option but to run X-AMP profile 1 which has the speed of 2933.
I really need help to get my ram to be able to run at the speed of 3200 again. please help !!
Ryzen 7 2700x
MSI x470 gaming plus
G.Skill RipJaw V 3200MHz
I bought my system about 4-5 months ago and my MSI x470 gaming plus has two X-AMP profiles for ram speed(profile 1 is 2933, profile 2 is 3200). When I first initially run my system for the first time(4-5 months ago) I was able to to set my X-AMP to profile 2 and run my ram speed at 3200 without a problem.
Until today when the problem just happened. I get into bios today just to check around and seen my ram speed only ran at 2133 even though my X-AMP profile 2 is still activated. So i tried to switch to profile 1 and save the setting and reboot the system and get into the bios again, it shown to run at 2933 without a problem. Then I tried to switch to profile 2 again to make them come back to the speed of 3200, after I save the setting and reboot the system just enter boot-loop states(it tried to boot but then shut off, repeat for about 5 times) and then it finally be able to boot up. Then I get into the bios to see if my ram will be running properly at the speed of 3200 or no, nope ! It shown that it's running at 2133 while my X-AMP profile 2 is still activate. I tried this multiple times and the result was always the same, I can't get it to run at 3200. I even tried to deactivate the X-AMP and do my own custom ram speed and voltage, still can't get it to run at 3200.
Right now I got no option but to run X-AMP profile 1 which has the speed of 2933.
I really need help to get my ram to be able to run at the speed of 3200 again. please help !!