I i recently got my case the cooler master haf 912 case and i have a but of trouble. I installed the motherboard (should i make sure the screws are very tight?) in the case. My motherboard is a Pegatron Corporation Benicia 1.01, and i dont know where to plug in the jumper cables (like to make the front leds, power reset buttons and usbs). I cant find the mauel i think someone may have thrown them out! I dont know what to do!I dont know where to putthe cables in, well i know what panel it is but i dont know how to put to cables in like which jumper goes into which pin! the only one i managed to turn on was the power button. Can some please help me get this to work it will be greatly appriciated.
These are the jumper cables i have (i dont know i think that is what they are called)
Pwr switch 2 pins go in that one
reset switch 2 pins go in that one
HDD led 2 pins go in that one.
And 2 single pin led cables!
and where do i plug the usb think in?, do i have to install like a driver with it or something? cant seem to get it to work!
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01324212&lc=en&cc=us&dlc=en&product=3686671#
I think that is my mobo.
NEED MY PC TO WRITE ESSAY AND LAB REPORTS DUE TMR PLZ HELP!
It is a mobo from a hp computer
These are the jumper cables i have (i dont know i think that is what they are called)
Pwr switch 2 pins go in that one
reset switch 2 pins go in that one
HDD led 2 pins go in that one.
And 2 single pin led cables!
and where do i plug the usb think in?, do i have to install like a driver with it or something? cant seem to get it to work!
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01324212&lc=en&cc=us&dlc=en&product=3686671#
I think that is my mobo.
NEED MY PC TO WRITE ESSAY AND LAB REPORTS DUE TMR PLZ HELP!
It is a mobo from a hp computer