New pc build wont enter bios

[don321]

I'm building my first pc from scratch. After a successful boot to the Bios, I checked around the settings to make sure everything was working before i installed my os. Only the half of my ram was detected by my motherboard. I put all 4 pieces into quad channel arrangement like my motherboard manual said but only the two pieces left of the cpu were actually working. So i shut down and took them out to clean off any dust and tried again but this time it wouldnt boot at all. When i press the power button the fans and leds start working but my monitor never displays anything. Ive even tried using each stick of ram by itself but still wont start. I was looking forward to this build and am sad i cant get it to work. What should i try next?
Mobo: MSI x99a sli plus
Cpu: i7 5820k
Cooler: Corsair h60
Gpu: Asus Strix geforce 980ti
Ram: 4x4gb crucial 2133 ddr4
Psu: EVGA supernova 750 b2 (750watt)

 

[drpower]

Look to see how to reset your mobo, I don't think just pulling the battery out for a minute or two is enough.

 

[don321]

Look to see how to reset your mobo, I don't think just pulling the battery out for a minute or two is enough.

There's a reset CMOS button on the side but pressing it hasn't fixed the problem. My motherboard also has a second bios and i tried that but nothing. Should i just return the motherboard or ram?

 

[lodders]

Since this is your first build, You might be surprised how much force is required to insert memory. The plastic clips at both ends flip up when the memory is all the way in. I got this wrong first build I did.

 

[drpower]

You will be ok, just be patient and go slowly. I just finally fixed my X99 5820 980 ti build today. From shipping issues since Nov 15, then bios problems and the cooler being too big I'm on my way. I saw a video on YouTube to reset the motherboard he put a small plastic cap with a connector inside over two certain pins on the motherboard.

I think what you should do is call the manufacturer of the motherboard like I did today. The EVGA rep took me through some steps and we figured it out together.

 

[don321]

Since this is your first build, You might be surprised how much force is required to insert memory. The plastic clips at both ends flip up when the memory is all the way in. I got this wrong first build I did.

I made sure it clicked each time but im starting to think the mobo is just dead

 

[don321]

You will be ok, just be patient and go slowly. I just finally fixed my X99 5820 980 ti build today. From shipping issues since Nov 15, then bios problems and the cooler being too big I'm on my way. I saw a video on YouTube to reset the motherboard he put a small plastic cap with a connector inside over two certain pins on the motherboard.

I think what you should do is call the manufacturer of the motherboard like I did today. The EVGA rep took me through some steps and we figured it out together.

Apparently its dead so i guess ill get a replacement. Thanks for the help!

 

[drpower]

It's in a better place. RIP motherboard, say hi to my mouse if you see him.