So, I got a new rx 580 from powercolor.
I removed my old 380 and installed the 580, plugging in the 6+2 pin and the 6 pin power connectors.
I boot up the system and start to have issues with the monitor losing signal to the graphics card, as my display shows for 1-2 seconds and then goes black and starts to cycle through my display source options. When it reaches DP in, it stops and says "No signal" and then after 1-2 more seconds the display comes back. This then repeats.
This ONLY happens when I have the GPU selected I believe, as when I boot up the system with a clean DDU use, the system boots with "Microsoft basic render driver" and I can use the system, which is what I'm doing now.
In device manager, the card comes up under "Radeon RX 580 Series" and the fans are currently spinning with the LED on the card being on.
When I took out my 380 I did pop off the PCEI clip but nothing was broken on it and I simply reattached it.
I have read about this being a display port issue and I am using a Acer monitor that supports 144hz and I am using the displayport cable that came with the monitor, having no issues running 144hz on my old 380.
Does anybody have any ideas as to whats wrong? I really just want to be able to use my new card 🙁
I removed my old 380 and installed the 580, plugging in the 6+2 pin and the 6 pin power connectors.
I boot up the system and start to have issues with the monitor losing signal to the graphics card, as my display shows for 1-2 seconds and then goes black and starts to cycle through my display source options. When it reaches DP in, it stops and says "No signal" and then after 1-2 more seconds the display comes back. This then repeats.
This ONLY happens when I have the GPU selected I believe, as when I boot up the system with a clean DDU use, the system boots with "Microsoft basic render driver" and I can use the system, which is what I'm doing now.
In device manager, the card comes up under "Radeon RX 580 Series" and the fans are currently spinning with the LED on the card being on.
When I took out my 380 I did pop off the PCEI clip but nothing was broken on it and I simply reattached it.
I have read about this being a display port issue and I am using a Acer monitor that supports 144hz and I am using the displayport cable that came with the monitor, having no issues running 144hz on my old 380.
Does anybody have any ideas as to whats wrong? I really just want to be able to use my new card 🙁