A guy gave me this old PC to work on and I can not get it to display anything to a monitor. So far I have tried VGA, DVI, HDMI, along with installing a spare graphics card and trying that. I have tried a different PSU along with re-seating the Processor. I have tried removing the RAM and replacing one stick at a time and disconnecting all internal devices.
I also tried clearing the CMOS. I have a PCI mother board anaylzer and I am getting the code EE00 which does not make sense. According to the manual EE says "Looking for a floppy diskette in drive A: Reading the first sector of the diskette." This PC does not have a floppy drive.....00 says "code copying to specfic areas is done. Passing control to INT 19h boot loader next." The board has no internal speaker and I did order a speaker to hook up, but other than that I am lost. The MB manual says it has a crash free BIOS option, but I am not sure how to use it. I copied the BIOS to a USB drive and plugged it in, but I have no idea if it is doing anything.
I tried both the extracted ROM and compressed ROM. I did rename it per the MB manual. Anyone have any suggestions?
Thanks
I also tried clearing the CMOS. I have a PCI mother board anaylzer and I am getting the code EE00 which does not make sense. According to the manual EE says "Looking for a floppy diskette in drive A: Reading the first sector of the diskette." This PC does not have a floppy drive.....00 says "code copying to specfic areas is done. Passing control to INT 19h boot loader next." The board has no internal speaker and I did order a speaker to hook up, but other than that I am lost. The MB manual says it has a crash free BIOS option, but I am not sure how to use it. I copied the BIOS to a USB drive and plugged it in, but I have no idea if it is doing anything.
I tried both the extracted ROM and compressed ROM. I did rename it per the MB manual. Anyone have any suggestions?
Thanks
Last edited by a moderator: