Question Rog Ryujin 240 aio issues

[Rubadan]

I have a asus strix 570-e motherboard.
Previously I had a Rog Lc 120 aio installed.
I upgraded to a Ryujin 240 recently but get issues off the bat.
Whenever the usb2 header is plugged in, all my RGBs begin to flash and the bios on the motherboard is wiped.
If the usb header is not plugged in, the cooler runs fine.
I have tried 2 different Ryujin 240 and get the same issue.
I know i am under load as the build uses 610.

I have already tested each component and everytjing works.
I have attempted with 2 power supplies, a gigabyte p850gm and a 750.
I have gone down to the bare and it will make jist the motherboard and q-code flash

I have reset cmos, reinstalled bios.

Complete set up is
AMD ryzen 9 5900x
Rog strix 570-e gaming mb
Wd black 850 ssd
2 x 16gb ballistix 3200 modules
Aorus xtreme 3090

Ran out of ideas here.
Anyone else run into an issue like this.

 

[Lutfij]

Welcome to the forums, newcomer!

You sure you've connected the USB connector to the header in the right orientation? The Gigabyte PSU's aren't something I'd recommend anyone buy, even if you're on a budget.

What BIOS version are you currently on for your motherboard?

 

[Rubadan]

Welcome to the forums, newcomer!

You sure you've connected the USB connector to the header in the right orientation? The Gigabyte PSU's aren't something I'd recommend anyone buy, even if you're on a budget.

What BIOS version are you currently on for your motherboard?

The power supply came with the graphics card, so i figured why not.
Currently running the newest, 3603 i believe.
Yes, the header has a missing pin, so only one way to insert it. There are 2 in the board.
I had the lc 120 plugged into the same header with no issue.