I recently got new components for a pc and I successfully assembled it. I have a ryzen 7 3700x and a msi b450 pro max with 3600mhz corsair vengeance ram. I was using the pc normally until my friend mentioned that unless i turn xmp on in bios my ram wont run at full speed. I was upset to find the the 3600mhz ram that i bought was only running at 2666mhz. I turned xmp on and rebooted to find that my pc doesn't start, i reset my bios and tried again to no success. It turns out i had to manually increase the voltage to get it to work. It is currently at 1.43v and it seems to run fine but i am concerned that i could be damaging parts. Should i reduce the voltage and the speed of the ram or should i keep it as it is right now. i also forgot to mention that i increased my voltage as little as possible for it to just work at the speed my ram is running at.