Striker 2 Formula wont POST

[HeadHunter12]

I have had an e8400 in a Striker 2 Formula for two months. It's been running without any problems until it suddenly crashed. I wasn't using the computer when it crashed. I pressed the reset button and it didn't post. I turned it off, unplugged the power cord and jiggled the cords on my mobo and other hardware just to make sure one of the cords didn't pop out. I tried turning on the comp again but it wouldn't post . The LED poster is stuck on CPU INT and the screen stays black. I have also cleared the CMOS. I have reseated the video card, tried swapping out the RAM, taken out and put the BIOS battery back in and I have even reseated the CPU.

Help would be appreciated =]

 

[boonality]

Try swapping power supplies before you do anything drastic. I got a CPU code out of the blue after 2 years of solid operation on an ABIT motherboard, swapping the power supply fixed it.

 

[roadrunner197069]

What ind of PSU do you have.

SOunds like it toook a crap.

 

[HeadHunter12]

I have a pretty damn good PSU Power & Cooling Quad Silencer 750w

 

[boonality]

That is a nice one, doesn't mean it didn't die though.

 

[HeadHunter12]

All the fans are spinning, and it has only been 2 months. I have read on the ASUS forums that the previous board, the Striker Extreme had the same problem as the Striker 2 Formula. It is very common apparently. I'm gona try and use the solution that works on the Extreme board.

http://vip.asus.com/forum/view.aspx?SLanguage=en-us&id=20070809190240609&board_id=1&model=Striker%20Extreme&page=1&count=55

 

[roadrunner197069]

If the +5v went bad on the psu you get symptoms that you have. Try a different one to rule it out.

If that dont work maybe you overheated something and killed it. Dieing unattended is usually bad psu or burned components.