Hey guys,
I have a problem with my monitor since yesterday. More below:
So, I have an LG 29WK500-P ultrawide display. Yesterday my graphics card died so I replaced it with my previous one, a Radeon R7 360.
My problem is when I boot my PC and log in to Windows 10 the display's resolution is on 1920x1080. However if I open the display settings menu I have a visible and recommended native resolution (2560x1080).
As soon as I click on the mentioned native res. my PC restarts itself (Monitor says: No signal, entering power safe mode), but my resolution stays the same.
This restart problem persists all of the other resolution options, so I can change it whatever I want to, stays in 1920x1080.
What I've tried to do:
I used the R7 360 with this monitor for half a year so that's not the problem.
Fully reinstalled the proper drivers with DDU.
Different cables.
EDIT: I have a 2 monitor setup. The secondary one is a 1920x1080 and it's connected to the same graphics card. When I try to change its resolution the dialog box shows up and offers the 'Keep changes' and 'Revert' choices. The primary display rather restarts the PC somehow.
I hope someone can come up with a solution,
Thank you
I have a problem with my monitor since yesterday. More below:
So, I have an LG 29WK500-P ultrawide display. Yesterday my graphics card died so I replaced it with my previous one, a Radeon R7 360.
My problem is when I boot my PC and log in to Windows 10 the display's resolution is on 1920x1080. However if I open the display settings menu I have a visible and recommended native resolution (2560x1080).
As soon as I click on the mentioned native res. my PC restarts itself (Monitor says: No signal, entering power safe mode), but my resolution stays the same.
This restart problem persists all of the other resolution options, so I can change it whatever I want to, stays in 1920x1080.
What I've tried to do:
I used the R7 360 with this monitor for half a year so that's not the problem.
Fully reinstalled the proper drivers with DDU.
Different cables.
EDIT: I have a 2 monitor setup. The secondary one is a 1920x1080 and it's connected to the same graphics card. When I try to change its resolution the dialog box shows up and offers the 'Keep changes' and 'Revert' choices. The primary display rather restarts the PC somehow.
I hope someone can come up with a solution,
Thank you
Last edited: