Ok I've posted here before and I've worked out the issue but this time I am stumped. Ill give the whole story.
My mother was using the blowdryer this morning which blew a fuse for the top floor of the house while I was using my PC. So I go throw the switch to get the power back on. I go to boot my pc it starts up then shuts down. I had this issue before so I figure it was the 24pin plug that came loose again so I popped open the case pushed it in and the power came back for a short while. As I go to close the case it shuts off again. So then I try to mess with the cord again and nothing happened. Then as I began inspected I kinda moved the motherboard alittle and it started up. I messed with the Power SW connector for my case. But now nothing turns on. I hear my power supply so I know its not dead I think when I moved the mother board I noticed a screw came loose that I used to keep the board in place. And it was setting on the back of my video card and when I went to grab it another came out and landed on the motherboard.
So my question is could the screws have caused a short or did I? Or maybe is it even shorted at all. I tried unplugging the power supply corresponding and re plugging yet no results.
Oh one more thing. The LED on the front panel of my case is on when the power supply is plugged in and on. Nothing else comes on.
My mother was using the blowdryer this morning which blew a fuse for the top floor of the house while I was using my PC. So I go throw the switch to get the power back on. I go to boot my pc it starts up then shuts down. I had this issue before so I figure it was the 24pin plug that came loose again so I popped open the case pushed it in and the power came back for a short while. As I go to close the case it shuts off again. So then I try to mess with the cord again and nothing happened. Then as I began inspected I kinda moved the motherboard alittle and it started up. I messed with the Power SW connector for my case. But now nothing turns on. I hear my power supply so I know its not dead I think when I moved the mother board I noticed a screw came loose that I used to keep the board in place. And it was setting on the back of my video card and when I went to grab it another came out and landed on the motherboard.
So my question is could the screws have caused a short or did I? Or maybe is it even shorted at all. I tried unplugging the power supply corresponding and re plugging yet no results.
Oh one more thing. The LED on the front panel of my case is on when the power supply is plugged in and on. Nothing else comes on.