I have a Lenovo Ideapad 300-15isk laptop.
And I recenty installed this (replacing old HDD): "WD Blue 3D NAND SATA SSD 2.5", 500 GB"
And installed this memory on the empty slot: "Samsung - M471B1G73EB0-YK0 - RAM 8Gb DDR3L, 1600 MHz, SoDimm 204pin"
Then I installed Windows 10 again from scratch, along with all drivers provided by the support page.
As you can see, RAM models are IDENTICAL and I can confirm that seeing CPU-Z screen.
Issue is that Windows 10 randomly hard-freezes (capslock and numblock presses doesn't switch their leds) and this happened twice in the first 6 hours of normal use.
I've already performed a memtest86 with a PASS outcome to all.
I've already upgraded my BIOS to the latest version.
BIOS settings are too simple, obviously 16GB are detected, but nothing on frequency/voltage customization settings.
What else should i try to do? I'm out of ideas and about to return the stick to the seller.
Does anybody have any advice?
Thank you very much!
And I recenty installed this (replacing old HDD): "WD Blue 3D NAND SATA SSD 2.5", 500 GB"
And installed this memory on the empty slot: "Samsung - M471B1G73EB0-YK0 - RAM 8Gb DDR3L, 1600 MHz, SoDimm 204pin"
Then I installed Windows 10 again from scratch, along with all drivers provided by the support page.
As you can see, RAM models are IDENTICAL and I can confirm that seeing CPU-Z screen.
Issue is that Windows 10 randomly hard-freezes (capslock and numblock presses doesn't switch their leds) and this happened twice in the first 6 hours of normal use.
I've already performed a memtest86 with a PASS outcome to all.
I've already upgraded my BIOS to the latest version.
BIOS settings are too simple, obviously 16GB are detected, but nothing on frequency/voltage customization settings.
What else should i try to do? I'm out of ideas and about to return the stick to the seller.
Does anybody have any advice?
Thank you very much!