Recent content by jasonbirder

That said it DOES seem to be CPU related as my system will happily run a GPU Test (Furmark) for 30 minutes with no signs of instability - which draws much more power than the CPU (Max 361W according to HWInfo) GPU - Palit RTX3080 10GB Gaming Pro

Is it even overheating that's causing me to restart? It just crashed/restarted 20 minutes into a 30 minute Cinebench test with temps never going above 80 degrees for package or any single core on the CPU...surely not hot enough for a crash/restart? Could it be PSU related but my PSU is less than...

PS AIO fan running at full RPm (3300 RPM) and case temps low (graphics card not getting above c50 degrees)

12700K on a Gigabyte z690 Auros Elite cooled bay a Lian Li Galahad 360 AIO My system has been restarting while gaming/while running stress tests in Cinebench... I was worried it might be CPU tempretures causing the freeze/restart issue... as CPU package temps were going up to 84/85 degrees with...

I'd rather not either but they don't have enough pins to be controlled from the fan headers...very strange....

THey the Lain Li SL fans...they're odd they don't take their fanspeed from the mobo in PWM mode...they follow a curve from their own sofftware...

I've got a flat 100% RPM as its the Pump for my AIO

OK...i've sort of sorted it...but its left me even more mystified! After undervolting by -0.05v my tempretures have come down about 5 degrees. I'm at about 10-15 degrees above ambient at idle...and I ran one pass of Cinebench multicore with tempretures topping out at c80 degrees...with no...

I've a 12700K running at stock cooled by a Lian Li Galahd 360 I have doubts as to whether its cooling correctly In BIOS it does say its running at c3300 RPM (CPU OPT Header) but my tempretures (in HW Info) bounce all over the place really rapidly - which you would think would be damped down by a...

Can anyone recomend a GPU support for my current build which is a 3 slot 3080 in a Lian Li 011 Dynamic Evo - built inverted... I liked the look of the Coolermaster ELV8 GPU holder...but it won't work on an inverted build will it? I also considered their ARGB GPU support bracket but couldn't find...

Thanks for your help...unfortunately even in PWM mode the fans spin at a fixed speed (presumably because the cable from the hub to the Fan header on the mother board is only attached to a single pin on the fan header.

You've probably already tried this...but is your RAM seated correctly? I only post because i had this problem and I was absolutely convinced it was a power problem to the mobo, i removed my cable extensions, I checked the cables, the pins for the ATX and CPU connectors, the Power Supply ands...

I realised i'm an idiot and didn't initialise the drives in Windows! Sorry

Hi...i've got 9 Lian Li UniFans (the SL120s) connected in 3 banks of 3 to the Unihub. I've got the L-Connect 2 Software installed. However, the fans all run at the same (static) speed, currently Max. There doesn't appear to be any facility to have the Fans speed up/Slow down in response to...

New build PC on Gigabyte Z690 Aorus Elite DDR4 Mobo Drives are viewable in BIOS (1 SATA HDD, 1 Gen 3 M2 SSD, 1 Gen 4 M2 SSD) i've installed Windows on the Gen 4 M2 SSD - but in Windows only a single Drive C: (the Gen 4 M2 SSD is visible) Any suggestions on a BIOS setting i've missed