Recent content by orkweh

Hehe, will do! :) My primary monitor is an Asus MG278Q (144hz). Secondary you see on the left in portrait mode is an Asus PB278Q (60hz). They are both connected via Displayport cables. If I plug the 60hz monitor into port 1 on my graphics card, and the 144hz monitor into port 2, BIOS will show...

Unfortunately it will not use the main monitor's refresh rate, but the way my monitors are connected to the graphics card at the moment allows me to see BIOS on the correct monitor (the one to the right). But windows want to set my left portrait monitor as number 1, and the right one as number...

I've got two monitors, my main 144Hz for gaming and one 60Hz in portrait mode as my secondary monitor. At first I noticed that my BIOS was showing up on the wrong monitor, the one that is sitting in portrait mode, which meant that I had to tilt my head 90 degrees to read. So I switched the...

No I'm using display port. I guess I'll try to get another DP cable or a HDMI cable and see if there is a difference

I'll try to keep it short. If I start my PC, then turn on the monitor, chances are it will say "no signal". I then first attempt to remove the display port cable from the back and insert it again. Sometimes that works and it gets a signal, other times I have to hit the reset button on my PC and...

I made a thread about this problem three years ago, at that time I had had my psu for two years and I still have it today. It's a Corsair AX860. Around 2015 it made a very clear pulsing noise, sounding like a cricket about once every second. I never did anything about it and it went away...

Hello, I've never had this problem before but since I moved to a new house I noticed that during the winter I build up static electricity very easily. It can be enough to just roll back on my chair and my feet glide over the floor just a few centimeters and I'll get a shock on my aluminium...

This has happened at least three times since I installed Windows 10, I don't recall it happening on W8.1. Most of the time when I turn my pc off it will shut down like it should. But sometimes it just stays on and you can't do anything other than hold down the power button to turn it off...

So I'm not sure how this will work, will I be able to make a DVD or a USB with W10 and perform a clean install? Can I do this right away after downloading the 3GB? Or do I have to upgrade and then perform a clean install after that? My 8.1 is a full retail license, will the W10 upgrade become...

Thanks for the replies guys. I have ruled out the power strip as I tried with my old power strip as well as having the pc plugged in directly to the wall and I still heard the noise. The noise isn't always there, but I started hearing it right now and decided to write here again. I said in my...