Recent content by stenterstal

Will take out the cpu to check if pins are bent but CPU installation went fine as far as I know

Updated it to the latest version

It's 2x16GB packaged together.

Did just that but with voltage set to 1.35V the system only boots with 1 stick using the A1 channel, booting with 1 stick in the B1 channel doesn't anymore. (Booting with both sticks still results in the same behaviour as before). Also when going in the BIOS -> Advanced Mode -> Ai Tweaker with...

I have tried keeping it running for 5 minutes (maybe not long enough). I don't know how to identify the system boot looping but the fans stay constant spinning after power up and there is constantly no video output. Regarding the voltage, does this mean the RAM is oncompatible? Can I manually...

Hello all, On my most recent build I'm struggling to get my dual channel RAM working and have no idea on what next steps to take. My motherboard is an ASUS PRIME H410I-PLUS/CSM which supports up to 2 x DIMM, Max. 64GB, DDR4 2666/2400/2133 MHz Non-ECC, Un-buffered Memory (From their website)...

So I don't know if this was just a coincidence or luck but I shifted the sticks around and it seems more stable now? Is this even technically possible or will it become unstable in the future and crash on me again?

Hello everyone, So I recently bought 8gb(2x4) ram modules from corsair (CMY8GX3M2A2400C11R) to upgrade my ram from 8gb to 16gb. I already had the same 2x4 modules so I now have 4x4gb of the same ram in my pc. After playing around with it for a while I noticed that my system had become very...

I got the problem now, there is a fault in the chassis fan connector. I think i've fried it sometime before when I tried installing my new case with fan hub. My fans are now running full speed, but the hub is plugged in with cpu_fan. Is there any way to fix the full speed issue? Also i didnt...

My upgraded specs are; Intel I7 4790S Asrock fatal1ty z97 (Hp motherboard before) Corsair Vengeance pro 2400mhz red(brand-less HP memory before) Psu: Corsair CX600M MSI GTX 970 24 & 8 pin are both connected to the motherboard. When I start the computer the cpu fan will spin for 1mm and the...

Hello everybody, My PC doesn't start anymore after upgrading from my old HP motherboard (From my old HP 500-306nd) to a new asus z97. When I click the power button the lights will turn on for 0.5s and then immediately turn off again. To my knowledge everything is plugged in correctly. Has...

If I would buy a 2560x1080 29 inch ultrawide monitor would that be okay? Because the inch would also go further in width if you know what I mean.

Will I lose any display quality if I would use a displayport to vga adapter to plug in my monitor? And what is the max inch size I should buy with a 1080p screen? Also, is ultra-wide a thing for gaming and movies?