Recent content by Vilo

I have this in my bios: Vcore Voltage Mode: CPU Vcore: Dynamic Vcore: Thank you in advance.

Thank you very much for your answer! Just yesterday I tried disabling Enhanced Multi-Core Performance and it didn't make any changes ... the temperatures under stress were the same. I am going to try the other options that you indicate to me. The bios on my board has a "Voltage Optimization"...

@Phaaze88, I don't have much experience with undervolt or overclocking issues. Could you tell me what parameters I should touch in the bios to "tame" the temperatures of the i7-10700K a bit? My motherboard is a Gigabyte Z490 UD. Thank you very much in advance!

Sapphire RX570 8gb

Thank you for all the guidance you have provided me. I have 3 options: Modify the front panel of the H200 so that more air enters. Change cabinet. Change to a liquid refrigerator and place it on top. Option 1 (although it is the cheapest) is not possible at the moment since the cabinet is...

Would you advise me to change for a liquid cooling system?

No, I only used cinebench to test this new montage. The equipment is mostly used for image editing (photoshop), office tasks and some (little) video editing with Davinci Resolve. Likewise, these temperatures worried me a bit, because with my previous PC (i7-7700) it did not go above 80ºC with...

The truth is that I just bought all this hardware (motherboard processor, RAM, cooler, ssds, cabinet etc.) to build a new pc. Everything is new... I don't see many options other than to make holes in the panel hahaha What do you advise me?

Thanks for your answer. I tried again by removing the front panel of the H200 and the maximum temperatures are now between 85º and 86º

Is it normal for an i7-10700k to hit 93º / 94º peaks in cinebench? I use it with a Cooler Master MasterAir MA610P in a Themaltake H200 cabinet (3 front coolers and one rear). With office tasks, the cpu works between 35º and 40º. Thanks.

Hi I recently bought a CoolerMaster Masterair MA610P with dual Masterfan MF120R RGB. I have 3 coolers on the front of the cabinet that bring air from the outside to the inside of the equipment. I also have 1 cooler at the back of the cabinet that draws the air from inside the equipment to the...

Thanks for your answer! I just plugged it into power and jumpered the contacts to turn it on. It lit up fine and the voltages seem to be correct. How bad is the power supply?

Hi. I just bought an Aerocool Advanced Technologies Cylon 700w Full Range 700w Black Power Supply. I have not installed it yet, I have not even connected it to the electrical network. but when I take it out of the box and remove the nylon, I smell like burning ... I don't know if it will be...