Recent content by VJ_Gamer

Your Laptop manufacturer will support until windows vista. If you are installing windows 10, there will be driver issues on your laptop. Peace.

You wont get any use from the driver if you install it. You can connect the monitor to motherboard and install it but the driver won't be helping you in anyway. Peace.

It probably isn't spinning because the video card isn't getting required load to get hot enough. First, check to see if the fans on your GPU initially start spinning for a few seconds when you boot up your computer. They should then stop spinning. Edit:- Question changed, Check if the GPU is...

Press the fn + F6 or F7 Key at the same time and check if it works. Edit:- If its not helping then try pressing Fn + F3 or Fn + F5 or Fn + F9 or Fn + F11 keys. Peace.

You can install it but the driver wont be finding the GPU for it to work with as you will be connecting your monitor to your motherboard. But its better to stick with the default driver now as you never know if the display works or not using that driver. if it works then fine and if not you need...

The 3200Mhz ram will automatically downclock to 2400Mhz. Peace.

Buy a Z77 motherboard LGA1155. ASRock - Z77 Extreme4 would be good but I'm not sure if it fits your budget. Peace.

10 short beep ：CMOS error(https://www.gigabyte.com/Support/FAQ/816). Have you seated the CMOS battery properly? And about the CPU error, Check if there is any connection issues with the CPU cooler. Peace.

You are welcome. Peace.

Your motherboard has driver support until windows 8 64bit. So you have to use the windows 10 default drivers. There are no drivers provided by your manufacturer for windows 10. Windows 10 will be installing the default drivers on it installation. For your GPU go...

No, You cannot mix DDR2 with DDR3, DDR with DDR2 and so on. Even DDR3 with DDR3 of different speed will cause a compatibility issue. I'd recommend getting the exact same type of RAM. Peace.

Yes, you can increase and it will also enable the dual channel on your motherboard. But make sure you use the same ram you are carrying now or a match in all aspects coz you may face compatibility issue. Peace.

if you shift from 1.2V to 1.35 there wont be much discharge on your battery, but when you increase the sticks you may find the difference. Better stay with 2400mhz since it is recommended and you never know if 3200mhz ram will work on you laptop. And volt doesn't just depend on speed. 2400mhz...

There have been same issues before with CPU error and the computer still boots up. Its not that the computer will not boot, but the bios is detecting there has been some hardware issues on your PC. 5 beeps a CPU error as per the beep codes on Gigabyte website. Try clearing cmos and try removing...