Question 4 Pin Power Connecter for DIYPC case, no 4 pin connector on PSU

[Turnips420]

Hello yall,
I recently purchased a DIYPC Vanguard case which uses a four pin power connector to power the four integrated fans. It would appear that there are no available inputs on the PSU, and even if there were, it does not appear that the connector would fit being that the shroud is solid.
Below are pictures of the PSU and 4 pin female connector.

https://imgur.com/a/jloTXOa

View: https://imgur.com/a/jloTXOa

Any suggestions?

 

[ohio_buckeye]

That is a molex connector. One of your cables on the modular psu should have that connection. If not you may be able to find a sata to molex power adapter but be sure to get a good quality one if you go that route.

 

[Karadjgne]

Black 6pin where it says 'Peripheral - Sata'. Your psu should have a wire with a 6pin on one end for the psu and 2-3 molex plugs down it's length. That's where you plug in the fans, to the cable, not the psu.