Hi everyone, I'm trying to figure out what is causing my issues, but I'm at an absolute wits end. I've tried both Escape from Tarkov and Squad (both of which should run 100+ FPS at 1080p), and neither game seems to want to go above 25FPS regardless of what I try. GPU utilisation in game never goes above 40% maximum (usually around 10%), with power draw generally being at 25%. CPU utilisation is always around 10% as well. When I run benchmarks, everything runs at full speed and full power which makes me feel like everything hardware wise is functioning properly.
Specs of the computer are as below:
CPU: AMD Ryzen 5 5600X
RAM: G-Skill 16GB (2 x 8GB) 3600Mhz CL16
GPU: Powercolour 6600 XT Red Devil 8Gb (Latest AMD Driver)
Mobo: MSI MAG B550M Mortar WIFI
SSD: Samsung 970 Evo Plus 500Gb
PSU: Coolermaster V Gold 850W V2
So far, I've tried reseating the GPU, changing power cables and slot on the PSU; I've tried every software/power management option I could think of, I've updated my BIOS and all my MB drivers, and made sure BIOS settings like XMP and SAM are activated. All the software changes have improved my FPS slightly (from 10 to 25 average), but I just can't figure out what the potential problem could be.
Before I send it off to get tested by a tech, or start RMA'ing parts I was just wondering if anyone has any potential solutions?
Specs of the computer are as below:
CPU: AMD Ryzen 5 5600X
RAM: G-Skill 16GB (2 x 8GB) 3600Mhz CL16
GPU: Powercolour 6600 XT Red Devil 8Gb (Latest AMD Driver)
Mobo: MSI MAG B550M Mortar WIFI
SSD: Samsung 970 Evo Plus 500Gb
PSU: Coolermaster V Gold 850W V2
So far, I've tried reseating the GPU, changing power cables and slot on the PSU; I've tried every software/power management option I could think of, I've updated my BIOS and all my MB drivers, and made sure BIOS settings like XMP and SAM are activated. All the software changes have improved my FPS slightly (from 10 to 25 average), but I just can't figure out what the potential problem could be.
Before I send it off to get tested by a tech, or start RMA'ing parts I was just wondering if anyone has any potential solutions?