So i picked up a new MSIg31m3 l v2 motherboard and an Intel Dual Core E6300 and an old antec sl350 power supply. I mounted the board, connected all i could, still dead... There was not a spot on the board for the power supply the big white plug 20 pin from the power supply. There was a spot for the 4 pin cpu power. DID I miss the ATX connector, it has one on the board but the plug from the antec power supply is to small to fit.
There seems to be no spot for some jumpers as well, these little back plugs, are the ground 1 & 2, +5 volt a few others, in the manual it says there are spots for some of the grounds but there is wires left over, The old board had a JP or something like that, where all these were supposed to be plugged in.
Any help and information will be greatly appreciated. Its alread too late, so I will check back tomorrow. Thanks for the help!
There seems to be no spot for some jumpers as well, these little back plugs, are the ground 1 & 2, +5 volt a few others, in the manual it says there are spots for some of the grounds but there is wires left over, The old board had a JP or something like that, where all these were supposed to be plugged in.
Any help and information will be greatly appreciated. Its alread too late, so I will check back tomorrow. Thanks for the help!