Question After Flashing / updating BIOS, now GPU (rx 7900 gre) is not being recognized and it stays on a black screen, iGPU shows display, please help

[Quackcake25]

Im using a MSI MAG B650 TOMAHAWK WIFI and had really slow boot times, so i tried flashing the bios to the newest version as i saw others had the same issue with boot time and it was fixed with a bios flash.

Sadly, after doing that my GPU is unable to be detected, black screen "no signal" appears and then it turns off. I am going crazy on how to fix this.

GPU worked perfectly before the bios flash and now the pc cant even detect the GPU.
PLEASE HELP

CPU: Ryzen 5 7600x
RAM: Corsair Vengeance 32 GB (2 x 16 GB) DDR5-5600 CL36 Memory

 

[TerryLaze]

Bios probably got reset and now boots on the igpu, there is a setting in the bios to choose which gpu to show while booting.

 

[Quackcake25]

Bios probably got reset and now boots on the igpu, there is a setting in the bios to choose which gpu to show while booting.

Either igp or peg, I've checked and it's on PEG, sadly still no display on the GPU

 

[TerryLaze]

Either igp or peg, I've checked and it's on PEG, sadly still no display on the GPU

Did you reset the bios to default after upgrading? Sometimes a bios will not accept changes in the settings if you don't do it.

 

[Quackcake25]

How would I be able to do that?

I've already tried and took out the cmos battery waited a couple of mins and put it back in yet still no display even when asked to press F2 to return bios back to its original state

 

[TerryLaze]

How would I be able to do that?

I've already tried and took out the cmos battery waited a couple of mins and put it back in yet still no display even when asked to press F2 to return bios back to its original state

In the bios there is an option, usually on the last page, that will say load default or something similar, it's different for each board maker.

 

[Quackcake25]

Just tried it now and still sadly the GPU still isnt being picked up by my pc, fack I should of never updated the bios

 

[Eximo]

Force the PCIe version to 3.0 and see if that helps at all. Auto negotiating can sometimes get weird, particularly if you are using a riser cable.