AMD 3500+ oc temp

[street_racer5]

well i using an AMD 64 130nm 3500+. It runs at 29C on stock hsf @ 2.2 ghz. When i over clock it to 2.4 ghz it goes to 33C. I have heard that after 2.4 it increases the temp dramastically. I am using the sotck hsf and i have a cooler master cm stacker case if your wondering about why temps are so low. Should i overclock it more or leave it at current temps

ASUS NF4 A8N-SLI-DELUX, AMD 3500+, MSI 256 6800GT PIC-E (NO SLI), COSAIR TWINX 1024MB 2-2-2, CM STACKER BLACK, 250WD HD S-ATA, AUDIGY 2ZS,

 

[endyen]

Too bad it's not a 90 nano chip. Most of the 130s seem to have trouble getting above 2.45, or 2.5. Just the same, they will usually get glitchy before they get hot. Just take the fsb up 1 or 2 mhz at a time. Run a little prime95 in between. If you have been able to config MBM5 for your board, use it. Sandra will also give temps. Good luck.

 

[Schmide]

Only if you enable it and install the driver.

Dichromatic for your viewing plesure...