I need to flash my bios to unlock tweaking which I hope will show intel xmp profiles so I can get my new ram to work at full speed relating to this thread:
The motherboard manufactures recommended this:
Flash BIOS SOP for UEFI Shell OS:
1, Copy BIOS folders into UEFI shell USB disk
2, Insert USB disk to B660H7-M20 M/B
3, Power on then enter BIOS setup Disable ME Disable secure boot Save and exit
4, Boot from UEFI shell USB disk
5, Go to “\RPL-B660H7-M20_221027\” folder
6. Run startup "and then press enter to start refreshing the BIOS
7. Refresh BIOS Pass and restart
8. Press DEL to enter the BIOS and load the BIOS default. Save and exit.
I am having difficulties getting these steps done, I assume I am not choosing the correct type for the usb so it is bootable, I am using rufus 4.6
choosing non bootable, GPT Target BIOS or UEFI and FAT32 file type.
The file they are asking me to run in step 6 is startup.nsh
Any help would be much appreciated. Thank you
Question - Need help with new ram purchased please
Hi, I am using a pre build medion p20 bandit, came with samsung 16gb ddr4 ram 3200hmz which runs at full speed. I tried to install Consair Vengance rgb pro ddr4 32gb ram 3200mhz into motherboard. Only running at 1064.1mhz per stick. Motherboard: B660H7-M20 There is no XMP settings on the bios...
forums.tomshardware.com
The motherboard manufactures recommended this:
Flash BIOS SOP for UEFI Shell OS:
1, Copy BIOS folders into UEFI shell USB disk
2, Insert USB disk to B660H7-M20 M/B
3, Power on then enter BIOS setup Disable ME Disable secure boot Save and exit
4, Boot from UEFI shell USB disk
5, Go to “\RPL-B660H7-M20_221027\” folder
6. Run startup "and then press enter to start refreshing the BIOS
7. Refresh BIOS Pass and restart
8. Press DEL to enter the BIOS and load the BIOS default. Save and exit.
I am having difficulties getting these steps done, I assume I am not choosing the correct type for the usb so it is bootable, I am using rufus 4.6
choosing non bootable, GPT Target BIOS or UEFI and FAT32 file type.
The file they are asking me to run in step 6 is startup.nsh
Any help would be much appreciated. Thank you