Question Case fans are only semi-working ?

[Cooldudealpha4]

I recently bought a Corsair spec delta case and the fans in the front were working fine until I did some cable management to the back to untangle them and now the top and bottom fan have stopped spinning. The RGB works fine in all 3 and the middle one spins but the other 2 stopped and I’ve tried plugging them into different slots on the motherboard and nothing is working. Anyone know how to help? I also went into BIOS and that didn’t help. Please help.

 

[LazerTechX]

If its PWM there should be two headers, one connects to the motherboard PWM header and the other one connects to an ARGB header. Maybe the PWM is disconnected. Or there could be a fan splitter that isn't connected properly.

 

[Cooldudealpha4]

If its PWM there should be two headers, one connects to the motherboard PWM header and the other one connects to an ARGB header. Maybe the PWM is disconnected. Or there could be a fan splitter that isn't connected properly.

They are not PWM fans sadly. They only have 3 slots for pins.

 

[LazerTechX]

They are not PWM fans sadly. They only have 3 slots for pins.

how many wires come from a single fan?

 

[Cooldudealpha4]

how many wires come from a single fan?

2. One for RGB and one for power. The RGB for all 3 fans are connecting to a splitter to plug into one slot

 

[LazerTechX]

Reseat or choose another header for your power connectors for the fan.

 

[Cooldudealpha4]

Reseat or choose another header for your power connectors for the fan.

I’ve tried that. I have 3 system fam slots and I’ve tried all of them with no luck

 

[LazerTechX]

I’ve tried that. I have 3 system fam slots and I’ve tried all of them with no luck

Your fans probably died, loose soldering from the factory or some stuff like that. Would replace it using the warranty

 

[Cooldudealpha4]

Your fans probably died, loose soldering from the factory or some stuff like that. Would replace it using the warranty

They died within 2 hours. How? Has to be the soldering. But the middle one still works

 

[LazerTechX]

They died within 2 hours. How? Has to be the soldering. But the middle one still works

Well sometimes you get unlucky with parts. Just like DOA parts or light bulbs that burn out in 2 days. Could still be caused by another factor though but if you can get it to work again after everything, I would get a replacement while its still under warranty.

 

[Cooldudealpha4]

Well sometimes you get unlucky with parts. Just like DOA parts or light bulbs that burn out in 2 days. Could still be caused by another factor though but if you can get it to work again after everything, I would get a replacement while its still under warranty.

Will do. Thanks for the help