Case Speaker Cable placement on my motherboard

[fernando2442]

I got my case and ASRock AB350M-HDV motherboard. Everything is connected properly but I have a speaker cable that came with the case. I can't find where to put it and the closest I have been is chassin intrusion and speaker header that has 7 pins. (4 across on top and 3 across on bottom.) It is next to the other case cables connections but am wondering if that is the right place to put it. Can someone help me figure this out? Thanks!

 

[azaran]

You've basically got it right. It'll depend on the cable your case uses, as some will use independent wires, other will use a larger plug. Either way it's just one ground (-) and one hot (+), plug it in to the appropriate header.

Top of page 29 of your manual shows it.
http://asrock.pc.cdn.bitgravity.com/Manual/AB350M.pdf

 

[fernando2442]

You've basically got it right. It'll depend on the cable your case uses, as some will use independent wires, other will use a larger plug. Either way it's just one ground (-) and one hot (+), plug it in to the appropriate header.

Top of page 29 of your manual shows it.
http://asrock.pc.cdn.bitgravity.com/Manual/AB350M.pdf

Okay, I thought that is where it went, I just hope I put it in right (positive on the left 1st) Thank you so much.

 

[azaran]

Signal side should be on the left. If it isn't then flip it if you're not getting the sounds you should be.