- Mar 22, 2018
- 14
- 0
- 10
Msi pro carbon ac z370
8700k
Evga gtx 1080ti
Corsair rm 750x
Samsung 256 ssd
1tb hdd
2 tn hdd
So today I purchased the 500d from Corsair and was swapping it from my 570x. I only replaced the radiator fans and took the fans from the old case. I hooked everything up and left a few wires hanging but just went to go see if it would boot. Which I was sure it would, the building process felt fine. When I plugged in the psu to the wall I noticed there was no led light for the debug. I’m pretty positive there’s an led because it’s been red and there’s a spot on the MB with debug led. I flipped the psu switch both ways multiple times and I’m pretty sure there’s no way I shorted it because the standoff’s are preinstalled. I know there are stories where people have loose screws that make contact to the case and motherboard that can short it. I didn’t see anything like thatz.Although I didn’t plug the 8 pin in all the way it was being stubborn and pushed it all the way in hoping that was it.Still nothing. But what makes me nervous is I unplugged everything plugged it back in a couple times still nothing. I even took out the MB and set it on it’s original case I had kept and I plugged in the 24 pin and the 8 pin with just the cpu and ram. Nothing else. No cooler obviously and I’m pretty sure that’s not bad to do? I really don’t know but no led so I am concerned about that. I’m exhausted and am going to try again tomorrow once I hear back from you guys hopefully. One thing i might try if you guys agree is try plugging in the original 8 pin that came with the psu. I have some black one from cable mod I believe as well as my 8+6 pin for my house. I currently have the MB and cpu on their own and the case and radiator and what not also separate. Please feel free to give suggestions.
8700k
Evga gtx 1080ti
Corsair rm 750x
Samsung 256 ssd
1tb hdd
2 tn hdd
So today I purchased the 500d from Corsair and was swapping it from my 570x. I only replaced the radiator fans and took the fans from the old case. I hooked everything up and left a few wires hanging but just went to go see if it would boot. Which I was sure it would, the building process felt fine. When I plugged in the psu to the wall I noticed there was no led light for the debug. I’m pretty positive there’s an led because it’s been red and there’s a spot on the MB with debug led. I flipped the psu switch both ways multiple times and I’m pretty sure there’s no way I shorted it because the standoff’s are preinstalled. I know there are stories where people have loose screws that make contact to the case and motherboard that can short it. I didn’t see anything like thatz.Although I didn’t plug the 8 pin in all the way it was being stubborn and pushed it all the way in hoping that was it.Still nothing. But what makes me nervous is I unplugged everything plugged it back in a couple times still nothing. I even took out the MB and set it on it’s original case I had kept and I plugged in the 24 pin and the 8 pin with just the cpu and ram. Nothing else. No cooler obviously and I’m pretty sure that’s not bad to do? I really don’t know but no led so I am concerned about that. I’m exhausted and am going to try again tomorrow once I hear back from you guys hopefully. One thing i might try if you guys agree is try plugging in the original 8 pin that came with the psu. I have some black one from cable mod I believe as well as my 8+6 pin for my house. I currently have the MB and cpu on their own and the case and radiator and what not also separate. Please feel free to give suggestions.
Facebook
Twitter
Instagram