I been overclocking a lot, getting whole bunch of errors. So if wanna make sure everything is intact or fully functional after those errors, meaning getting a relevantly “clean bios”, do I just flash the bios again or just do a cmos clear? Which one is more clean or let’s say more thorough. More wipe out everything type? Or either one is okay?
My board is Apex Z890, CMOs is a button on the rear panel.
Also, I always not sure what’s the best way to use this CMOs, so I cut the power completely (switch off the PSU) or just shut down the PC is fine? (While all the lights still glowing in my case)
Thanks u!
My board is Apex Z890, CMOs is a button on the rear panel.
Also, I always not sure what’s the best way to use this CMOs, so I cut the power completely (switch off the PSU) or just shut down the PC is fine? (While all the lights still glowing in my case)
Thanks u!
Facebook
Twitter
Instagram