My brand new PC has been having troubles posting every boot up and I've done everything I could with checking monitor/cables, updating BIOS and clearing CMOS with no luck. I've only realized that the EZ Debug LED CPU light turns on then off after a few seconds but then doesn't continue and the DRAM light does not come on as it's supposed to. I have tried booting both by themselves in the second DIMM slot and both times they've booted only sometimes and other times haven't so I can't say one particular stick is faulty. After several changes of combinations with both sticks in and some luck the monitor gets signal even though the same combinations didn't work minutes ago. When it does finally posts the EZ Debug LED goes from CPU then skips DRAM and continues to VGA. I've always made sure they are installed correctly and in the correct DIMM slots. The RGB on the RAM sticks have always powered on if it doesn't post. Once it connects with the monitor it is fine to run all day and the system recognizes both sticks just fine.
Going by the EZ Debug there is a problem with the RAM sticks since post or not the LED does not turn on but having them sometimes work and sometimes not may indicate a problem with the motherboard. Does anyone have any suggestions? Specs below.
Going by the EZ Debug there is a problem with the RAM sticks since post or not the LED does not turn on but having them sometimes work and sometimes not may indicate a problem with the motherboard. Does anyone have any suggestions? Specs below.