I was using the g connector to connect my front headers but I put my led negative into the wrong place how do I remove pins it doesn’t say in the manual
The easiest way is to pull off the whole connector and then attach each wire to the correct pin and then replace it.I was using the g connector to connect my front headers but I put my led negative into the wrong place how do I remove pins it doesn’t say in the manual
Replace what?The easiest way is to pull off the whole connector and then attach each wire to the correct pin and then replace it.
Yes so what happened is I connected the power switch to the power led and now I need to remove the connectors from the g connector itself but they don’t seem to come out just by pulling.If you are talking about a Gigabyte G connector, the front panel wires attach to the G and then the G attaches to the motherboard front panel header.
They will come off if you pull the clip back, like in THIS video.Yes so what happened is I connected the power switch to the power led and now I need to remove the connectors from the g connector itself but they don’t seem to come out just by pulling.