Hey folks,
I'm running out of ideas here..
Gigabyte Gaming K7 X370,
2 x 8GB Ripjaws,
RX 580,
EVGA 850W Modular PSU,
Red Devil RX580 8GB,
2 4TB HDD, 2 240GB SSD.
First of all, system is running flawlessly since December, 2017.
No hardware change since.
Few weeks ago I wanted to boot from my old HDD, and noticed, that I can't get into the BIOS, neither to the BOOT Setting
As the motherboard posts, hitting del - or F12 for boot settings - causes "entering bios" or "entering boot settings" , and then nothing happens, hard reset required
Once, I left it there for an hour, to see, if it goes to the BIOS. It didn't.
Windows boots perfectly, no issues with stability, or anything else for that matter.
Also, I can't get into BIOS through the Windows App either.
Reinstalled Windows 10, no change.
So far I tried all these, many times:
Cleared CMOS with the jumper many times. (leaving power cord, then unpluged power cord)
Changed CMOS Battery twice (once I even left pc unplugged for over 24 hours)
Disconnected all hardware, except VGA, used one RAM.
Updated BIOS via @bios (first to F25, then F30, then F42)
Switched to backup bios via Jumper.
Switched to SB from MB via Jumper.
After all these, same issue.
Ideas?
Edit: just checked with CPU-Z, BIOS runs in default.
Means 1066 MHZ memory, no XMP profile.
I'm running out of ideas here..
Gigabyte Gaming K7 X370,
2 x 8GB Ripjaws,
RX 580,
EVGA 850W Modular PSU,
Red Devil RX580 8GB,
2 4TB HDD, 2 240GB SSD.
First of all, system is running flawlessly since December, 2017.
No hardware change since.
Few weeks ago I wanted to boot from my old HDD, and noticed, that I can't get into the BIOS, neither to the BOOT Setting
As the motherboard posts, hitting del - or F12 for boot settings - causes "entering bios" or "entering boot settings" , and then nothing happens, hard reset required
Once, I left it there for an hour, to see, if it goes to the BIOS. It didn't.
Windows boots perfectly, no issues with stability, or anything else for that matter.
Also, I can't get into BIOS through the Windows App either.
Reinstalled Windows 10, no change.
So far I tried all these, many times:
Cleared CMOS with the jumper many times. (leaving power cord, then unpluged power cord)
Changed CMOS Battery twice (once I even left pc unplugged for over 24 hours)
Disconnected all hardware, except VGA, used one RAM.
Updated BIOS via @bios (first to F25, then F30, then F42)
Switched to backup bios via Jumper.
Switched to SB from MB via Jumper.
After all these, same issue.
Ideas?
Edit: just checked with CPU-Z, BIOS runs in default.
Means 1066 MHZ memory, no XMP profile.