Question High voltage after XMP enable - VENGEANCE LPX 32GB (2 x 16GB) DDR4 DRAM 3200MHz C16

[rt08]

Hi all!

So, first build, enabled the XMP profile for the VENGEANCE LPX 32GB (2 x 16GB) DDR4 DRAM 3200MHz C16 on my GIGABYTE X570 AORUS ELITE. I'm not sure if there's a real issue here. No BOSD or other problems (also no improvements in fps CoD Warzone) just that the voltage in BIOS after enableing the XMP shows 1.39v. In the tech specs of the ram they say tested voltage is 1.35V. What to do? To mention that i didn't updated the BIOS to the latest version due to a prior build wich ended in a deat mobo and no boot at all after the flash BIOS update to the latest version.

 

[RealBeast]

1.39V should not be an issue for your memory.
I would run the free version of Memtest86 though to insure its stability; 2 or 3 full runs without error and you are fine.

 

[rt08]

1.39V should not be an issue for your memory.
I would run the free version of Memtest86 though to insure its stability; 2 or 3 full runs without error and you are fine.

Thanks for reply! Did the test, no errors. 😬