Question Lian Li Strimer cables, Corsair RM850e PSU, and Asus Dual 4070 Super EVO - - how to connect them all together ?

[itsdeezy]

My GPU uses a 12VHPWR connector and comes with an adapter to connect to 2x 8 pin PCI-e slots in my PSU, but I don't think I would use that with the Strimer?

However, I'd like to use the Lian Li Strimer. The cable I think I need is the 12VHPWR to 3x 8 Pin PCI-e slots, as I do not believe there is one that goes from 12 to 2x 8 pin.

Do I take 3 separate PCI-e connectors and plug into each of the 3 8pins coming from the Strimer? Or would I only plug in 2 of them like the adapter would have?

Strimer link

PSU link

GPU link

Alternatively, is there a different Lian Li Strimer cables I would buy for this set up?

Hope I've provided enough information.

 

[Lutfij]

Welcome to the forums, newcomer!

You should be good to go, just leave on of the 8pin adapters unpopulated. Ideally, I'd have looked into a PSU that had native 12VHPWR support so you didn't need to deal with a bundle of cables and Lian-Li make a harness that stems from the PSU and terminates at the GPU without any adaptors, i.e, this one;

https://www.amazon.ca/Lian-Li-Strimer-12VHPWR-Light/dp/B0C13GWNP4/

Moved thread from Components section to Power Supplies section.

 

[itsdeezy]

Welcome to the forums, newcomer!

You should be good to go, just leave on of the 8pin adapters unpopulated. Ideally, I'd have looked into a PSU that had native 12VHPWR support so you didn't need to deal with a bundle of cables and Lian-Li make a harness that stems from the PSU and terminates at the GPU without any adaptors, i.e, this one;

https://www.amazon.ca/Lian-Li-Strimer-12VHPWR-Light/dp/B0C13GWNP4/

Moved thread from Components section to Power Supplies section.

Thanks for the response!

So just to get a little visualization!

It goes
GPU connected to Lian Li Strimer 12VHPWR to 3x8 Pin --> 2x 8 pin from PSU connects to to 2 of the 3 8-pin adapters, with the 3rd not being used.

and that's because the GPU only draws enough power to make use of 2 of the PCI-e spots in the GPU and a 3rd would be pointless?

For some reason this has been breaking my brain to think about lol

 

[RAIDGoblin]

You should be good to go, just leave on of the 8pin adapters unpopulated. Ideally, I'd have looked into a PSU that had native 12VHPWR support so you didn't need to deal with a bundle of cables and Lian-Li make a harness that stems from the PSU and terminates at the GPU without any adaptors, i.e, this one;

https://www.amazon.ca/Lian-Li-Strimer-12VHPWR-Light/dp/B0C13GWNP4/

forgive me if I'm wrong, but the PSU the OP linked is ATX 3.0 and says it comes with a 12VHPWR cable, would they not be better off using the Lian Li Strimer V2 cable that you linked here?