Memory "asynchronous" need help to 1:1

mkha0246

Distinguished
Nov 9, 2008
28
0
18,530
ok guys this is the first time i overclocked and i set all the settings that needed to be set to disable and enable. i have the fsb at 340 and the multiplier 9.5 so on my E7200 @ 3.2Ghz at Rated FSB 1363.8Mhz.

but my problem is that i want my memory at 1:1 but right now its at 4:5
therefore the DRAM frequency is at 426.2MHz and i have 4096MBytes and the first stick of ram is at PC2-1200(72 MHz) but my second one is at PC2-6400 (400MHZ) why???????? is that supposed to happen when u change the fsb and if not how can i change the divider back to it??

what should i do!!!????
my specs are:
E7200 @ 3.20GHz
Asus P5Q-Pro
Corsair 4096MBytes at PC2-6400 DDR2-800 5-5-5-18
 
yah there are in the correct slots but when i overclock my cpu fsb the memory ratio changes and results in the settin listed above. but is it that the DRAM frequency is more accurate than the SPD tab in CPU-Z??
 
ok so i overclocked my cpu fsb to 340 and the multiplier is at 9.5 so my E7200 @ 3.20GHz and now my ram is at 5:6 ratio and at 400MHz and now ive been running prime95 now for now 12 mins w/o any errors but ill see if i wanna run it longer.

just wanted to know if the ratio is good??? and if the speed is good now cuz before it was 4:5 and the first stick was at 72MHz and now both sticks are at 400MHz
 
ok so i have passed my prime95 test for more than 8hrs and with no errors and sandra memory test and have seen the highest load temp of 50 degrees Celsius.
my only consern now is if i want to increase the speed of my corsair 4GB DDR2-800 ram and its at the max fsb of 400MHz at stock voltage, what should i do that i can increase my cpu speed and ram speed and wat voltage settings should i use?????