Whenever I screwed the screws into the standoffs not all of them went fully in. I screwed them until they were snug and stopped a little before over tightening them - so they are actually tight.
The screws went in 95% of the way, some went all the way. Buy when I push on the bottom of the motherboard for example, the motherboard goes back, is it alright to leave it like this? If i try to screw more it feels like I will be over tightening the screws. My system runs fine as I went ahead and built it despite the problem, but just wanted more opinions. Also should the standoffs actually come up through the holes? Or should I be able to look through the holes and see them?
The screws went in 95% of the way, some went all the way. Buy when I push on the bottom of the motherboard for example, the motherboard goes back, is it alright to leave it like this? If i try to screw more it feels like I will be over tightening the screws. My system runs fine as I went ahead and built it despite the problem, but just wanted more opinions. Also should the standoffs actually come up through the holes? Or should I be able to look through the holes and see them?