Hello, thanks for taking the time to read my post/question.
I just purchased and installed a new Crucial SSD M4 drive (CT128M4SSD2). I plugged the cable into the SATA6 1 port (brown) and my old WD hard drive into the SATA6 2 port (brown). Made sure they were both enabled in the bios and set the proper boot priority. I decided to do a fresh install of Windows 7 64bit as well. Everything went fine, booted up to the login screen. But I did notice while booting up, the bios flash stated that there were no hard drives detected. When I just had the WD HD installed, it would show that during boot up. In addition, when I have windows up, it gives me the option to eject both drives (as ATA) under the "Safely remove hardware and eject media" tool bar at the bottom right.
I was wondering if both of the occurences listed below is normal operation? Or is it something I should be worried about?
Thanks in advance for any help.
I just purchased and installed a new Crucial SSD M4 drive (CT128M4SSD2). I plugged the cable into the SATA6 1 port (brown) and my old WD hard drive into the SATA6 2 port (brown). Made sure they were both enabled in the bios and set the proper boot priority. I decided to do a fresh install of Windows 7 64bit as well. Everything went fine, booted up to the login screen. But I did notice while booting up, the bios flash stated that there were no hard drives detected. When I just had the WD HD installed, it would show that during boot up. In addition, when I have windows up, it gives me the option to eject both drives (as ATA) under the "Safely remove hardware and eject media" tool bar at the bottom right.
I was wondering if both of the occurences listed below is normal operation? Or is it something I should be worried about?
Thanks in advance for any help.