Question Pc wont load after upgrading.

[Jidge]

I upgraded my pc only kept tge case and the nvme and 2 ssd’s both sata connected.

Specs:
Amd 7700 x
Amd Rx7800 Xt
2x 16gb DDr5 ram sticks.
Gigabyte B650 motherboard.

All turns on lights up etc but I can’t get it to show signal or show anything on monitor. Have got a red light “DRAM” illuminated.

Read online that it takes time to first boot after building but I have left it on for 40 mins still not showing signal.

Have tried switching ram around but at a loose ends and don’t know what to do…

 

[Bob.B]

I upgraded my pc only kept tge case and the nvme and 2 ssd’s both sata connected.

Specs:
Amd 7700 x
Amd Rx7800 Xt
2x 16gb DDr5 ram sticks.
Gigabyte B650 motherboard.

All turns on lights up etc but I can’t get it to show signal or show anything on monitor. Have got a red light “DRAM” illuminated.

Read online that it takes time to first boot after building but I have left it on for 40 mins still not showing signal.

Have tried switching ram around but at a loose ends and don’t know what to do…

Remove the gpu and connect the monitor to the mobo....test.

 

[Jidge]

Didn’t work still the same issue

 

[ohio_buckeye]

Remove gpu and try a single stick of ram. Also does your board have a bios flashback function? If so you may want to update the bios using that, though since 7000 series was the first wave of am5 processors I would think it would be compatible.

 

[Bob.B]

Didn’t work still the same issue

Unplug all disk...test.