Question Pc wont start after oc

[crystalrena]

specs:
MSI MEG B550 Unify
R5 5600x
Aorus 1080ti
Cougar GX 800w
G.Skill Ripjaws V 32gb 3200

Q: I tried oc cpu and ram. After restart my pc wont boot, all coolers working but no image at all. Debug hex okay then start repeating 32-37 hex, ez degub led shows vga and boot.

I’ve tried clearing cmos (cmos button and jumper)
-not worked
Rubbing ram with rubber -not worked

if anyone know what to do, pls write me. also will add video soon.

 

[Ralston18]

This motherboard?

https://download.msi.com/archive/mnu_exe/mb/MEGB550UNIFY.pdf

[Confirm that I found the applicable manual.]

When you rubbed the RAM with rubber did you reinstall the RAM correctly?

Provided that I correctly identified the applicable motherboard manual the first physically installed RAM must be install in DIMMA2

Reference Page 18 of the manual.

Will the pc boot as before?

If so reset the clocking to the original values.

First objective is a sucessful boot and the second objective is to restore stable performance - without overclocking.

[Note: Overclocking requirements can be addressed later. There may be little or nothing to be gained by overclocking.]

 

[crystalrena]

This motherboard?

https://download.msi.com/archive/mnu_exe/mb/MEGB550UNIFY.pdf

[Confirm that I found the applicable manual.]

When you rubbed the RAM with rubber did you reinstall the RAM correctly?

Provided that I correctly identified the applicable motherboard manual the first physically installed RAM must be install in DIMMA2

Reference Page 18 of the manual.

Will the pc boot as before?

If so reset the clocking to the original values.

First objective is a sucessful boot and the second objective is to restore stable performance - without overclocking.

[Note: Overclocking requirements can be addressed later. There may be little or nothing to be gained by overclocking.]

yes, this motherboard. i install em in 2 and 4 slot as it was before. also i was oc ram timings (also there is vid youtube.com/shorts/xXHsieRfASA?si=k_F46_IsnSfi90wV)

 

[Ralston18]

To be clear: DIMMA2 was installed first - correct?

If the PC will still not start then refer to the User Manual and double check that all connections are correct and fully and firmly in place.

Connectors, cards, RAM, jumpers, and case connections need to be checked.

Check all diagnostic LEDs. Do you hear any beep codes?