Please tell me if this will work...

[fatboy123]

Hello and thank you so much for your time, I'm a newbie but very willing to learn and do the work, I just need the go ahead from you guys.

My equipment:

one WiFi 4 port router LINKSYS E1200
one WiFi 4 port router D LINK DIR 614
one non wireless 4 port router D LINK DI 604

one 4 camera security system with it's own DVR
300 Meters of Cat 6e Ethernet cable


What I want to do is:

A: To connect LAN 1 to LAN 2 such that I can view the CCTV cameras connected to LAN 2 from LAN 1 without lag.

B: To share the ADSL internet line connected to LAN 1 on LAN 2.


My simple question is can this be done. If it can than I will do the research and find out how to set it up.

The distance between LAN 1 and LAN 2 is 300 meters (900 feet) so do I just need to put one repeater in between? There is only one cable between these two location and not possible to draw another cable.


The picture below explains better what I want to do...

NOTE:
The reason there are two routers in LAN 2 is that the DVR+PC2+PC3 are located 50 meters away from PC1 and where the 300m cable from LAN 1 is located.

I Thank you all so very much in advance.

 

[fatboy123]

All I need is a simple YES or NO answer, along with any short descriptional notes you feel like adding. Thanks again.

 

[oct]

Yes... With repeater on 300m cable (to be on the safe side). Set dhcp on e1200, and set all other router to AP mode.

Note... you said "no lag in viewing camera's"... are the cameras wireless or wired? If they are wired and ip camera's, I would consider adding a cheap switch to bypass your 2 routers in LAN 2. Then use the 2 routers as repeater's if electrical power is available.

Also how are you going to power repeater's... POE?

 

[fatboy123]

Thank you for your answer oct, although I finished the job last month, I did exactly as you suggested and they are all working perfectly, the cameras were normal wired analog cameras and everything is super smooth.

Thanks again.